Generation Against Load
Inverter output, building consumption and grid import appear on one timeline in the same units.
Inverters, sub-meters and the incoming supply all speak Modbus or MQTT with different register layouts. IoTServa normalizes them so energy balances can be read, not rebuilt.

Solar output, building load and grid import are measured by different devices with different units and timestamps. Reconciling them by hand each month hides losses and faults between the meters.
Inverter output, building consumption and grid import appear on one timeline in the same units.
An inverter reading low against its neighbours shows up in the data before the monthly report.
Tenant and department consumption is attributed from the same history that drives dashboards.
Interval data leaves as CSV or through the API for billing and sustainability reports.
Each one is read natively and joins the same tag model.
Poll Modbus RTU and Modbus TCP devices, decode registers with the right word order and scaling, and publish clean engineering values.
See Modbus IntegrationRead meters, drives, controllers and instruments that speak over RS-485 or RS-232 serial lines. The edge gateway holds the serial port and polls each device, so the cabling never has to reach the internet.
See Serial Bus IntegrationSubscribe to any broker, publish normalized data back out, and keep topics, QoS and retained state under control.
See MQTT IntegrationStart with the main incomer, the inverters and two sub-meters. Add irradiance if you want to compare output against expectation.
BACnet and Modbus both run buildings and plants, but they model data differently. Compare their networks, discovery and addressing, and see where each fits.
Read the GuideA Modbus reading is only as good as its register map. Learn the 40001 address offset, word order and scaling mistakes that give plausible but wrong values.
Read the GuideA consistent MQTT topic scheme saves years of pain on multi-site projects. See a simple convention, what to avoid, and how QoS and retained messages fit in.
Read the GuideIoTServa records what the meters report. Billing-grade accuracy depends on the meters and your tariff process, not on the platform.
Yes, through one device profile per model. Brands that expose Modbus or MQTT can share the same tag names.
Tell us which protocols are on site. We will scope a pilot that reads your real devices.