Soil and water monitoring
Moisture, level and flow readings arrive from remote points with their battery and signal health.
Plantations, farms and large sites use LoRa sensors for soil, water, weather and tanks, sending a few bytes over long distances. IoTServa decodes and keeps them.

Large sites have no cable plant and unreliable cellular coverage. Sensors must run for long periods on batteries and report small readings across kilometres.
Moisture, level and flow readings arrive from remote points with their battery and signal health.
Rain, wind and temperature from a weather station join the same history.
Level and pump state from Modbus or LoRa devices on the same map.
Gateway and sensor health shows where signal is weak before data goes missing.
Each one is read natively and joins the same tag model.
Receive LoRaWAN uplinks through your gateways, decode payloads into engineering units, and manage thousands of low-power sensors.
Read MoreSubscribe to any broker, publish normalized data back out, and keep topics, QoS and retained state under control.
Read MorePoll Modbus RTU and Modbus TCP devices, decode registers with the right word order and scaling, and publish clean engineering values.
Read MoreStart with one block of land, one gateway and a mix of soil, weather and tank sensors. Check coverage at the farthest sensor first.
A LoRaWAN gateway needs some backhaul to reach IoTServa. Where coverage is poor, a satellite or fixed link is common.
Malaysia uses AS923. Gateways and devices must be set to it.
Tell us which protocols are on site. We will scope a pilot that reads your real devices.