IoTServa Get Started
Hardware

VYROX Hardware, Ready for IoTServa

VYROX supplies the gateways, sensors and meters, ready for IoTServa. It also reads compatible equipment your site already has, so you only add what is missing.

A flat-lay of industrial IoT hardware: a DIN-rail gateway, serial converter, LoRa sensor, Bluetooth beacon and clamp meter

Six Kinds of Hardware

Edge Gateways

DIN-rail gateways and fanless industrial PCs that run the protocol drivers beside the equipment.

RS-485EthernetOutbound TLS

Serial Converters

Serial converters that bring Modbus RTU onto the network, and MS/TP-to-BACnet/IP routers for MS/TP trunks, which need proper routing rather than a transparent serial tunnel.

Modbus RTUMS/TP

LoRaWAN Gateways and Sensors

AS923-1 gateways for indoor and outdoor use, with sensors for temperature, humidity, level, soil and doors.

AS923Battery Sensors

BLE Gateways and Tags

Room-level BLE gateways, beacons and environmental tags for presence and short-range sensing.

ScannersBeacons

Energy Meters

Clamp-on and DIN-rail meters with Modbus output for sub-metering and power quality.

ModbusThree-Phase

KNX Interfaces

KNX IP interfaces and routers that let IoTServa listen to the bus and, where allowed, command it.

KNX IPTunnelling

Check These Before You Buy

Five questions that prevent most hardware regrets.

  • Confirm the radio region plan. LoRaWAN hardware for Malaysia must support the AS923 plan, and the AS923-1 variant, across gateways and sensors.
  • Confirm the output. Meters and sensors should expose Modbus, BACnet, MQTT, LoRaWAN or BLE in a documented way.
  • Ask for the register map or payload decoder before you order, not after.
  • Check the environment: temperature range, ingress protection and mounting for the site.
  • Plan power and backhaul for gateways, especially on remote sites.

Not Sure What to Buy? Send Us the Site Details.

Tell us which protocols are on site. We will scope a pilot that reads your real devices.

WhatsApp